1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

So this is frustrating ...

Discussion in 'Using Alibre Design' started by wazzu83, Apr 5, 2021.

  1. wazzu83

    wazzu83 Senior Member

    So, I've added a couple of sketch nodes to a drawing. Can't seem to select them using any of the constraint tools? :mad:

    Using HOOPS.

    Where's The Football?
     
  2. HaroldL

    HaroldL Alibre Super User

    Are you working on a 2D drawing or in a part 2D sketch? Can you provide a screen shot?
     
  3. wazzu83

    wazzu83 Senior Member

    2D drawing environment.

    Worked through it. Not exactly sure why, but if I turned off snap to grid the sketch node became selectable. Turn on snap to grid and it wasn't. It wouldn't even select by drawing a box around it. So weird.

    I am at the office today using a different computer. So far, everything is working as one would expect.

    Go figure.
     
  4. NateLiqGrav

    NateLiqGrav Alibre Super User

    In Alibre Design Drawings each View and Sheet can have its own independent sketch. Make sure you have the correct View or the Sheet selected before entering sketching mode.
     
  5. wazzu83

    wazzu83 Senior Member

    Your suggestion was not the problem. All items sketched in the active view were selectable, except nodes. See my note above. Very odd behavior.
     

Share This Page