1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Libre Link doesn't run with V21SP1 (Resolved)

Discussion in 'Using Alibre Design' started by GIOV, May 15, 2020.

  1. GIOV

    GIOV Senior Member

    Hello everyone,
    I'm trying to use Libre Link but it doesn't work properly with V21SP1. I would like to know if this is something from my particular system or something that is happening to everyone, and if it is from my system how can I fix it?
    Take care.
    Corrected:V21SP1
     
    Last edited: May 17, 2020
  2. GIOV

    GIOV Senior Member

    This behavior is when I open Draft WorkSpace.
     
  3. simonb65

    simonb65 Alibre Super User

    SP2 ?????
     
  4. HaroldL

    HaroldL Alibre Super User

    :confused::confused: Is this something new? What is it? How is it used with Alibre? :confused::confused:
     
  5. GIOV

    GIOV Senior Member

    Ok. Start Librelink before Alibre
    upload_2020-5-16_18-43-56.png
    Start LibreOffice;
    upload_2020-5-16_18-54-27.png
    Open Assemble;
    upload_2020-5-16_18-57-57.png
    Now do the link from LibreLink to the AD Assemble and update each parts of the assemble ;
    upload_2020-5-16_20-3-23.png
    Now Open Drawing WorkSpace of the assemble;
    upload_2020-5-16_20-7-56.png
    Now go to the LibreOffice and modify the measure of the Variable independent (as Example);
    upload_2020-5-16_20-8-53.png
    Now Go to LibreLink and update again each part of the assemble;
    upload_2020-5-16_20-11-38.png
    upload_2020-5-16_20-12-45.png
    Now Save the assemble WokSpace;(this step is absolute necessary for update the Drawing Workspace).
    Finally update the Drawing Workspace with "reproject View" tool;
    upload_2020-5-16_20-19-47.png
    HaroldL and Simon65 I did this example for your of the right procedure to run LibreLink including DrawingWorkSpce. If you open the drawing before LibreLink it doesn't run in my system.
    Thanks and Take Care,
    GIOV.
    Version: V21 64-bit [Build 21034]
     
    Last edited: May 16, 2020
  6. simonb65

    simonb65 Alibre Super User

    @GIOV, my point was that v21.0.2 (21034) is SP1. SP2 hasn't been released yet!
     
  7. GIOV

    GIOV Senior Member

    I
    Ok, SP1.
    I hope in SP2 Reproject View will run as AD12 where wasn't necessary open assemble WorkSpace.The changes in the spreadsheet (Excel&Open) was directly to the Drawing WorkSpace through "Reproject View". I don't have Libre Office & LibreLink in my old 32 bit Laptop.
     
    Last edited: May 17, 2020

Share This Page