1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Flexible wire ruining my constraints.

Discussion in 'Using Alibre Design' started by anson, May 14, 2020.

  1. anson

    anson Member

    Can anyone tell me why my constraints are overdefined in this assembly. I'm kinda new to 3d sketching, so I'm blaming it on that but not sure what I'm doing wrong.
     

    Attached Files:

  2. JST

    JST Alibre Super User

    Something seems to be very strange, since every constraint I tried is overdefined, even though I had removed the "anchored" status, AND suppressed the wire, plus I removed all active constraints before adding mine.

    The "wire" has some errors active on it, and often errors active on any part or subassembly will cause errors in the next higher assembly, or further up the line.
     

Share This Page