1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Face and edge selection problems

Discussion in 'v22 Beta' started by juhaszzs, Sep 17, 2020.

  1. juhaszzs

    juhaszzs New Member

    Face and edge selection problems

    It is works on program start. I use "Shaded and visible Edges". I can only select visible edges and faces. Is is ok.
    When I switch the "Shaded and All Edges" I can select non visible edges too. It is ok.

    I switch back to "Shaded and visible Edges" mode. I can select non visible edges too. It is wrong. Very difficult to select anything.

    I switch to "Shaded" mode. I can select non visible edges too. It is wrong. Very difficult to select anything.

    I switch to "Illustration" mode. I can only select visible edges and faces. Is is ok.

    I switch to "Wireframe" mode. Hidden edges selection not working. Is is not ok.


    Switch from "Shaded and visible Edges" to "Wireframe" mode. I can select non visible edges too. It ok.


    Summary:
    Only the "Illustration" mode disable hidden edges selection mode.
    Only the "Shaded and visible Edges" mode enable hidden edges selection mode.

    I've submitted a beta ticket.
     

Share This Page