1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Design Explorer Assembles's Part Properties

Discussion in 'Using Alibre Design' started by GIOV, Sep 1, 2020.

  1. GIOV

    GIOV Alibre Super User

    Still have issue to download the script &file. Only is able to download resources. I will try in my oldest 32 bits and I let you know.
     
  2. idslk

    idslk Alibre Super User

    downloaded it a few seconds ago - no issues here...
     
  3. GIOV

    GIOV Alibre Super User

    No issues for download the file from my 32 bits machine. :)
    I'm glad you improved your script. I'll run it again in my ADEV21 64 bits and let you know.
    Regards,

    GIOV
     
    Last edited: Sep 8, 2020
  4. GIOV

    GIOV Alibre Super User

    Run very well Stefan! I will try a more complex model later and let you know.
    upload_2020-9-8_21-40-24.png
    Regards and thank very much,
    GIOV
     

    Attached Files:

    Last edited: Sep 8, 2020
  5. idslk

    idslk Alibre Super User

    Updated the script to Version V013a in this Thread.

    Regards
    Stefan
     
  6. GIOV

    GIOV Alibre Super User

    Thanks Stefan, I do like you put the new version in this threat.
     
  7. idslk

    idslk Alibre Super User

    If i get more results from different people, i will open a "Script release" thread for the script...

    Regards
    Stefan
     
  8. GIOV

    GIOV Alibre Super User

    Stefan,
    Here is the result for a imported model near to 240 STEP parts.
    All material is the same.
    Model unit distance: mm
    upload_2020-9-11_16-51-18.png

    upload_2020-9-11_16-49-12.png

    Material List
    upload_2020-9-11_16-43-56.png
    Same Parts give:
    upload_2020-9-11_16-54-54.png
    So as I said above, your scrip need have type of material input and its unit in reference of the distance unit imported model.
    The accuracy is 11%. It will be great less than 5%...
    Despite of this well done Stefan.
    Ok.
    Thanks very much for the effort.
    GIOV
     

    Attached Files:

  9. GIOV

    GIOV Alibre Super User

    I run again the script after assign the material and its name:
    upload_2020-9-11_21-50-8.png
    I
    upload_2020-9-11_22-11-46.png
    Congrats Stefan.Your Script doing excellent in my old 64 bits Laptop Toshiba Satellite. :)
    Only you need assign the material mass from base unit model imported which in this case is mm.
    Recheck if you do a mirrored parts because the error in my previous post was only in these parts.
    GIOV
     
    Last edited: Sep 12, 2020

Share This Page