1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Default dimension for up and down adjustment arrows

Discussion in 'General Discussion' started by ROB101, Nov 13, 2019.

  1. ROB101

    ROB101 Member

    I searched and couldn't find this one. Every time I press the up and down arrow for adjusting spacing or extrusion length, it goes up by 163.871. I can't find where to adjust this so it only goes about .250, or something like that. Any advice? Thanks.



    ADJUSTMENT ARROWS.png
     
  2. Ralf

    Ralf Alibre Super User

    Hi Rob101,

    Please take a look: Spinner Increment
    Spinner-1.jpg
     
    jfleming, MKR, IonSteve and 2 others like this.

Share This Page