1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Auto-populate weight in 2D drawing.

Discussion in 'Tutorials and Tips from the Community' started by Global Supplier, Feb 22, 2018.

  1. Does any one know if it is possible to make a 2D drawing automatically update and populate the weight field?

    Thanks!
     
  2. bigseb

    bigseb Alibre Super User

    Not through the part properties as one normally would unfortunately. Hopefully that will be fixed with the upcoming release. There was a workaround using a separate BOM (I think) but I can't quite remember how that works. If I recall correctly DavidJ may be the one to ask.
     
  3. Thanks! Using a BOM is the best solution this far, not optimal maybe, but it seems there's no better alternative. Hope they fix it in the upcoming release.
    Thanks again bigseb!
    Peace
     

Share This Page