Discussion in '3D Printing' started by bigseb, Jul 2, 2014.
Post photos of your 3D prints here. Include print settings if you like.
Layer height: 0.1mm
Circuit casing for RC builder.
Layer height: 0.1mm
Wall thickness: 0.8mm
What is the nozzle size?
Created a piece to be mounted on top of a Gearbox/Stepper assembly to fit a PCB with switches and optocouplers.
Printed by ShapeWays and shown is the test-rig.
The 'Red" levers are also 3D printed
Y-Axis Stepper Mounting Bracket
Layer Height: 0.1mm
This is the Cyber Beast from Thingiverse, printed at 0.19 mm layers with with fill and Z-ABS (Zortrax's ABS filament)). It's a little more interesting than the simple parts I've tried thusfar GMD designs.
Guitar nut and bridge:
Pencil / business cardholder (full size 2"-600# RFWN Flange) Render & Photo
What printer did you use?
Hit the "ReCon Engineering" with some gold leaf for "pop!"?
I used cubify.com
.......I haven't used them since because their prices more than quadrupled
It is hard to see in the picture of the actual part (not the rendering) that the extruded text of Re-con Engineering was very fine. I revised the model and re uploaded to Cubify. Original price to print Approximately $70. After I changed that text to extruded cut (same as my name) the price quoted after uploading was over $300 !!
I contacted Cubify and asked why such a tremendous jump in the price, and was told they had changed the "algorithm" used to calculate the price had changed. Needless to say I did not have my project reprinted and have not used them since.
They priced themselves out of my business.......I was very satisfied with the print....but I cannot justify those prices
Something I made for my wife; a garlic house for storing garlic and ginger. Material used is HIPS.
Another one for my wife: a tea buddy. Material is also HIPS.
Seb, I love the garlic housing and want one
Cheers Wattie. Have a look here.
Impeller. High impact polystyrene.
This is a large flat dish that I originally intended to be a test after switching to a glass build plate. It is 200mm x 130mm x 20mm. The idea was to see if I get could better adhesion with ABS slurry on glass than Kapton and boy did it work. I was never able to print with PLA before because the part would always start curling up at the edges. Not anymore though. This dish stayed stuck to the build platform and is 100% flat (no rocking).
No. of shells: 1
Floor/roof thickness: 0.4mm
Separate names with a comma.