1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

dlaery's Recent Activity

  1. dlaery attached a file to the thread constrain to an edge.

    ok i see what worked, thanks

    4.jpg May 5, 2021 at 8:57 AM
  2. dlaery replied to the thread constrain to an edge.

    I tried inserting a plane on the 2 edges of the angle and that didn't work 1st try. thanks, I will check these suggestions out.

    May 5, 2021 at 8:38 AM
  3. dlaery posted a new thread.

    constrain to an edge

    i am trying to constrain the edge of the angle piece to the face of the cylinder, but all it wants to do is constrain to the axis. What...

    1.jpg 2.png 3.jpg

    Forum: Using Alibre Design

    May 5, 2021 at 7:58 AM